In this example, the speakers are connected to the outputs 1: Output Left and 2: Output Right of the audio interface (the output name might be different on your computer depending on which audio interface you use). Select the audio interface outputs that your speakers are connected to. Open the Audio & MIDI Settings panel from the File menu and go to the Routing tab, then click the Outputs button.If the output meter is not showing any amplitude, follow the steps below: When playing your guitar into GUITAR RIG, the output meter in the GUITAR RIG header should show an amplitude. In this example, the guitar is connected to 1: Input 1 (the input name might be different on your computer, depending on which audio interface you use) and we wish to use Guitar Rig 5 In L. Select the audio interface input your guitar is connected to. Switch to the Routing tab and click the Inputs button.In this example, we have selected RigKontrol3. Select your audio interface from the Device menu.Open the Audio and MIDI Settings panel from the File menu and switch to the Audio tab.Make sure that the volume of your guitar is turned up and the guitar is connected to the audio interface input you wish to use.

If the input meter is not showing any amplitude, follow the steps below: When playing your guitar into GUITAR RIG, the input meter in the GUITAR RIG header should show an amplitude. You should now see (and hear) an output signal. If your Studio Monitors or Speakers feature a volume control, make sure this volume is also turned up.Ensure that the Master Volume slider is set to an acceptable level in the GUITAR RIG header.Turn up the Volume slider as well as the Dry and Wet sliders. Open the PRESET VOLUME component by clicking the PRST button (vertical bar-lines) in the GUITAR RIG header and expand it by clicking the expand-tab button on the far-right side of the rack unit.If so, this will block the audio signal from passing through GUITAR RIG! Click the Mute button, so it turns grey. Open the TUNER component by clicking the 'tuning fork symbol' in the GUITAR RIG header and check if the Mute button is active.In this example, the speakers are connected to the outputs 1: Output 1 and 2: Output 2 of the audio interface (the output name might be different on your computer depending on which audio interface is used). Open the Preferences panel from the File menu and switch to the Audio tab, then click the Outputs button.In the GUITAR RIG plug-in version, the routing is configured in the DAW. Note: Step 1 applies to the standalone version only. If the output meter is not displaying any signal level, follow the steps below: When playing your guitar into GUITAR RIG, the output meter in the GUITAR RIG header should display a signal level. Turn the Input Gain slider to the right in the GUITAR RIG header.In this example, the L button is active because the guitar is connected to the L input (see previous step). Make sure that the corresponding input button ( L or R) next to the input level meter is active.In this example, we are using Guitar Rig 6 In L, since our guitar is connected to 1: Input 1 (the input name may be different on your computer, depending on which audio interface is used).

In this example, we have selected Komplete Audio 6 MK2.

Open the Preferences panel from the File menu and switch to the Audio tab.

Note: Steps 3 and 4 apply to the standalone version only.

Make sure the input gain of your audio interface (if available) is turned up.

Make sure that the volume of your guitar is turned up and the guitar is connected to the audio interface input that you wish to use.

If the input meter is not displaying any signal level, follow the steps below: When playing your guitar into GUITAR RIG, the input meter in the GUITAR RIG header should display a signal level.

Guitar rig fl studio